Opticon OPI 4002 - Manual (Page 22)

Opticon
OPI 4002
Instruction Manual
22
Notes:
1) In the Reading column, “ „” means Enable Reading and “X” means Disable Reading.
2) In the Transmit Code Length column, “ „” means Transmit Code Length and “X” means
“Do Not Transmit Code Length.
3) In the Transmit CD column, “ „” means Transmit Check Digit and “X” means Do Not
Transmit Check Digit.
4) In the Calculate CD column, “ „” means Calculate Check Digit and “X” means Do Not
Calculate Check Digit.
5) In the Prefix Settings column, “ „” means No Prefix Setting.
7.2. Default Settings 2: Read Options, Trigger, Buzzer
Item Default settings
Setting the number of characters Fixed length OFF all codes
Read mode Multiple read
Inter-character gap check (NW-7) Character *1 > Inter-character gap
Multiple columns read (barcode only)
Disabled
Trigger switch Enabled
Read time 2 seconds
Buzzer durations 200 ms
Table 6: Defaults: Settings, non-communications related
7.3. Default Settings 3: Communication Settings
Item Default settings
IEEE address Disabled
Wireless channel CH15
Encryption Enabled
Memorizing Disabled
Table 7: Defaults: Settings, communications related