Opticon OPN 2001 User Manual - Manual (Page 11)

OPN 2001 OPTICON - 11
Scan / Clear LED indicators
Green - flashing:
The Scan button is pressed and the laser is on. When the laser is aimed at
a barcode, the code will be read and stored in memory.
Green - solid:
A barcode was successfully read and stored in memory.
Red - solid:
While scanning: The barcode was read but the memory is full, so it can
NOT be stored in memory.
While clearing: The barcode was read but it could not be found in memory
so it can NOT be deleted.
Orange - flashing:
The Clear button is pressed. When the laser is aimed at a barcode, the
code will be read and deleted from memory.
Orange - solid:
The Clear button is pressed for more then 6 seconds. All data stored in
memory will now be cleared.
Buzzer indicators
MEDIUM, HIGH, MEDIUM:
While scanning: The barcode is added to memory.
While clearing: The “Clear all codes” sequence has been performed.
While setting a function: The buzzer is ‘toggled on’.
While the scanner is connected to the PC: The scanner is connected to the
PC, and the connect (or disconnect) command has been received:
MEDIUM, LOW, MEDIUM:
While the scanner is connected to the PC: The scanner is disconnected
from the PC, while the application did not disconnect the scanner.
2 x LOW, MEDIUM, LOW:
“Set all default” sequence has been performed.
LOW, MEDIUM:
The barcode is deleted from memory:.
A long LOW:
The barcode was not previously scanned, so it is NOT deleted.
HIGH, LOW:
The memory is FULL, the barcode is NOT added.