Orbit Baby Infant Car Seat G2 and Base G2 - Manual (Page 22)

Installing the Car Seat Base and Car Seat
42
42
42
42
Installing the Car Seat Base and Car Seat
43
43
43
43
A
B
C C
B
A
To un-install the car seat base and
remove it from your vehicle:
1. Turn the StrongArm knob
counterclockwise and reset the car seat
base StrongArm to zero (Photo A).
2. Push and hold the red button on each
LATCH/UAS connector and pull it off
the vehicle LATCH/UAS anchorage
(Photo B). Store the LATCH/UAS
connectors as shown (Photo C).
3. Using both hands to support the weight
of the base, remove it carefully from the
vehicle.
Un-installing the Car Seat Base:
With LATCH/UAS
Installing the Base:
With Vehicle Seat Belt
Before you install the car seat base in your
vehicle, make sure the vehicle is parked on
level ground.
1. The car seat base should be installed
without the car seat attached (Photo A).
Follow instructions in the Rotating and
Removing the Car Seat from the Car
Seat Base to remove the car seat from
the car seat base.
2. CHECK that the car seat base
StrongArm is set to zero (Photo
B). If not, turn the StrongArm knob
counterclockwise until the zero line is
visible.
3. If the LATCH/UAS belt is secured
on the lock-off clamp, remove from
clamp. (Note: The belt is permanently
tethered to the car seat base). Store
the LATCH/UAS connectors in their
storage location when they are not in
use (Photo C). Each connector will
click securely into its own storage slot.
4. If the vehicle seat back is adjustable,