Pavement Ends 51197 Replay - Manual (Page 4)

51197 pg 4 0710 Rev. C
Step Nine
I
NSTALL
T
OP
F
ABRIC ON
H
EADER
In order to install the top fabric, make sure that the
Center and Rear Bows are in the folded down posi-
tion on the rear of the vehicle.
Lay the top fabric, backing side up in the rear of the
vehicle with the plastic strip facing up and aligned
with the front edge of the header. Locate the round
hole that marks the center of the plastic strip (all
other holes are slotted). Install a screw in the round
hole to secure the fabric to the header as well as to
center the top. Then proceed to install screws in the
remaining seven or thirteen holes along the front of
the header.
Start with center
ROUND hole
Detail of Center
Screw Hole
Lay fabric, backing
up in rear of vehicle
Plastic Strip along
front edge of fabric
Start with center
ROUND hole
Align fabric
with header
Fabric
Plastic
Strip
Header
Tailgate
Step Ten
I
NSTALL
C
ORNER
S
CREWS
Flip the fabric over so that it wraps around the
header and drape the top fabric over the tailgate.
Raise the header slightly and work the pockets in
the fabric over the corners of the header. Install
an oval head screw in each corner to secure the
fabric to the header.
Detail of Header
Work pockets over
corners of header
Header
Install Screw to
secure fabric
Drape fabric over tailgate
Step Eight
If you have a 1997 vehicle with a slip-on plastic ex-
trusion on the door surround, it must be removed.
Pull down on the extrusion to work it loose.
Slip-On Plastic
Extrusion
Pull down on extrusion
to remove
Door Surround