Pavement Ends 51197 Replay - Manual (Page 8)

51197 pg 8 0710 Rev. C
Note: For the best results and to minimize
scratches on the windows, remove all
jewelry before installing the door covers.
Note: This door cover is designed to fi t very
tight on the door frame. We recommend using
a shoe horn to help work the corners of the
cover over the frame without tearing the fabric.
Do not pull on the weatherstrip to assist in getting
the door cover on the door frame. This will tear the
weatherstrip and the door will not seal properly.
Step Twenty-three
R
EMOVE
O
LD
D
OOR
F
ABRIC
Remove the fabric upper doors from
the vehicle. Use a razor knife to cut
the stitches on the old door covers
and take them off of the door frames.
Step Twenty-four
R
EMOVE
N
EW
D
OOR
C
OVERS
Unzip the windows and separate the hook and
loop fasteners on the door covers. Lay the door
cover on a fl at smooth surface with the outside
facing down.
Start by working the lower rear corner of the door
frame into the pocket in the lower rear corner of
the cover. Then work the lower front corner of the
frame into the cover. Work the top front corner of
the frame into the corner of the cover, between
the hook and loop fl aps (not between the zipper
and the fl ap). Finally, use the tab sewn into the
cover to work the last corner of the frame into the
corner of the door cover, again between the hook
and loop fl aps.
Make sure that the top edge of the door cover
is straight along the top of the door frame. Work
around the door fastening the hook and loop
strips tightly around the door frame. Once the
door cover is on the frame, the tab in the top rear
corner of the cover may be cut off with a pair of
scissors if desired.
Step Twenty-fi ve
I
NSTALL
D
OORS ON
V
EHICLE
Reinstall the upper doors. Insert the pins
into the grommets in the lower door.
Door Frame Between
Hook and Loop Flaps
Detail of Hook and Loop –
Top of Door
4. Use tab to install
Upper Rear Corner
1. Install Lower
Rear Corner
Unzip Window
before installing
Hook and
Loop
Weatherstrip
2. Install Lower
Front Corner
3. Install Upper
Front Corner
Detail of Hook and Loop –
Lower Front Corner
Hook and
Loop
Pull Flap
Up First