Pavement Ends 51139 Replay - Manual (Page 2)

51139 pg 2 Rev. D 0903
Top Fabric Assembly Qty - 1
Rear Curtain (Window) Qty - 1
Adhesive Hook Strip, 5/8" x 2" Qty - 4
3-3/4" Plastic Strip Qty - 1
Parts List and Hardware Identification
Remove Turnbuckles on
Tailgate
Remove Corner Screw
Relocate Snap from Tailgate to
Screw Hole
Tailgate
Rubber Seal Detail
View from Inside
of Vehicle
Pull up gently on
rubber seal
Remove Turnbuckles
Tailgate Retainer, Qty - 1, Part
Number 286.50
The appliation of the above part is
protected under U.S. Patent
#4,757,854.
1/4 - 20 Locknut, Qty - 9, Part
Number 198.26
Body Stud, Qty - 2,
Part Number 9.68
#6 Washer, Qty - 4,
Part Number 298.24
#6-32 x 3/4 Pan Head Screw,
Qty - 2, Part Number 298.23
#6-32 Locknut, Qty - 2,
Part Number 298.25
Tools Needed
Phillips Screwdriver
Flat Screwdriver
7/16" Wrench
10mm Wrench
50/50 Alcohol/Water Solution
Clean Cloth
Safety Glasses
1/4 - 20 Phillips Head Bolt,
Qty - 9, Part Number 257.92
Parts Shown in Actual Size
Step One
Remove the old top.
Lift up slightly on the rubber seal along the top of the tailgate to access
the nuts securing the seven “Lift-a-Dot” Posts to the tailgate. Remove
the “Lift-a-Dot” Posts.
Remove the corner screws, next to the tailgate on each side. Relocate
the snaps on each end of the tailgate to the screw holes on either side of
the tailgate.
F OR 1989 M ODELS O NLY : On 1989 models, there is a turnbuckle on each
end of the tailgate. Remove it. Use the Body Studs, #6-32 x 3/4 Pan
Head Screws, #6-32 Washers and #6-32 Locknuts from the Parts Kit.
Install the Body Studs with a washer behind the stud and one in front of
the nut.
FOR 1989 MODELS ONLY
Remove Turnbuckle and
Install Body Stud
#6-32 x 3/4 Pan
Head Screw
Body Stud
#6-32 Locknut
#6-32 Washers