Pavement Ends 51139 Replay - Manual (Page 5)

51139 pg 5 Rev. D 0903
Step Six
Locate the two 3" loop strips sewn to the inside of the top in the corner of the side
panels, between the Lift-a-Dots. Use the loop strips as guides to install the 5/8" x
2" Adhesive Hook Strips between the Lift-a-Dot Studs. Peel the backing off the
Adhesive Hook Strips and press them firmly into place. After installing the
Adhesive Hook Strips, fasten the loop strips on the side panel to the hook strips.
Hook and Loop Installation
The Adhesive Hook Strip in the parts kit fastens to the loop strip sewn into
the cover.
Use a 50/50 solution of alcohol and water to clean the locations for the
adhesive Hook Strip. Be sure to remove all dirt, silicone sealants, wax,
and any other substances which might prevent the adhesive from sticking
to the paint.
Note: Do not attempt to apply the adhesive hook in temperatures of less
than 60˚ F. The adhesive backing will fully set within 72 hours of
application. You may install the Top after about 12 hours, but you should
avoid unnecessary fastening and unfastening of the cover for 72 hours.
Adhesive Hook Strip -
Inside Side Panel
Step Seven
Locate the hook and loop strips sewn to the inside of the top
between the side windows. Wrap the strips around the bow
and fasten them to each other.
Inside of Vehicle
Hook and Loop
Strips
Rear
Window
Step Eight
Open the tailgate. Start on the passenger side and zip the
Rear Window to the top.
Zip Rear Window into
Top