Paxton LCD PROXIMITY reader kit - Manual (Page 4)

Page 4
Cable extensions
R
R
Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.
Wiring
The reader port module is designed to convert the
standard reader ports on Switch2 and Net2 controllers
to accept one or two RJ45 connections. Pull off the
screw terminal block from the reader port and simply
replace it with this module.
This module can be used to provide a connection point
for the reader RJ45 plug. The terminals on the module
are then wired colour for colour to the controller.
Alternatively, the reader can be wired directly into the
screw terminals of the control unit by first cutting off
the RJ45 plug and stripping back the wires in the cable.
Reader port module (325-030)
This module may be purchased separately to speed up
the installation and replacement of readers.
Connection modules
Further information on how to purchase Installer Tools is available at:
http://paxton.info/841
Reader junction box (325-020)
Connection to a control unit
reader port