Paxton TOUCHLOCK keypad Stainless Steel (485-374) - Manual

INS-006 Date code: 201200
TOUCHLOCK keypad Stainless Steel (485-374)
Contents of kit
TOUCHLOCK keypad Stainless Steel
TOUCHLOCK keypad Stainless Steel installation instructions
TOUCHLOCK keypad Stainless Steel mounting template
220 ohm resistor
Fitting kit
Suitability
Products
The TOUCHLOCK keypad is suitable for use with the Switch2 control unit (405-321) and the PC based Net2
control unit (489-334).
Environment
The keypad will operate between –20
o C and +70 o C. It is rated at IPX7 and so is suitable for both internal
and external use.
Where to use the TOUCHLOCK keypad
YES NO Reason why not
Low to high use doors Completely vandal proof Keypad is exposed
Inside and outside
No need to shelter from the elements
Narrow door frames
Architecturally sensitive installations
Fitting
• Using the template provided with the keypad, drill holes for the two screws and the cable.
• Extend the top of the cable hole to allow the keypad to slide down during fitting.
• Insert the raw plugs and screw the top 8 X 1” in only. Leave a gap of approximately 2mm between the
screw head and the face of the wall. Try the keypad on the screws and adjust as required.
• Once a good fit has been achieved, thread the cable through the wall and locate the keypad. Lock it into
place with the locking screw at the bottom. If being installed into a vandal risk area, a tamper resistant
security screw can be used.
Cable
TOUCHLOCK
keypad
stainless steel
8 X 1"
W all plugs