PIAA 510 Series User Manual
Page 4
HARNESS
INSTALLATION
• Before connecting any wires the negative (-) battery terminal should be disconnected.
• When connecting the wires on the harness follow the wiring diagram and
connect them as in the diagram.
• For proper lamp operation it is recommended that you connect the positive (+)
and negative (-) power supply wires directly to the corresponding battery terminals.
Do not take power directly from the alternator.
• As in the harness diagram you may connect the switch power (+) to the parking
lights or any other switched power. An alternate power supply for the switch
may be the high beam headlight.When you do this your PIAA lights will only turn
on when your high beams are on.They will turn off when you turn off your high
beams, and the PIAA lights will not work any other time.
• Do not connect lights to turn signals or to lights that flash with an automotive alarm.
• When running the wires through the engine compartment be sure to keep them
securely away from moving parts and systems, such as the fan and the throttle
cable and away from hot parts such as the exhaust manifold.