MacDon 742 HAY CONDITIONER - Manual (Page 57)

Form # 46290 Issue 09/05 55
MAINTENANCE/SERVICE
GREASING THE HEADER – 100 Hours (cont’d.)
8. Upper Cross Auger Support Bearing.
(optional) (H) - one fitting.
9. Gauge Roller Bearings (opt.) (C) – 4 fittings.
10. Gauge Wheel Pivot Bushings (optional) (D) –
two fittings.
500 Hours or Annually
1. Gauge Wheel Hub Bearings (optional) (A) –
two fittings.
GREASING THE HAY CONDITIONER
50 Hours
1. Hay Conditioner Roll Bearings (J) - four remote
fittings.
2. Hay Conditioner Belt Idler Pulley Bearings (K)
- one fitting.
UPPER CROSS AUGER SUPPORT BEARING
(OPTIONAL)
H
GAUGE WHEEL PIVOT BUSHINGS
(OPTIONAL)
GAUGE ROLLER BEARINGS
(OPTIONAL)
C
HAY CONDITIONER ROLL BEARINGS
(BOTH SIDES)
J
HAY COND. IDLER PULLEY BEARINGS
K
GAUGE WHEEL HUB BEARINGS
A