MacDon 5010 Mower Conditioner - Manual (Page 77)

75
ADJUST LINK TO CENTER OF SLOT
A
UNLOADING & ASSEMBLY
INSTALL HOOD AND DEFLECTORS
1. Loosen hardware J/K and F/G.
2. Swing hood into position.
3. Install hardware.
4. Install side deflectors.
5. Tighten all hardware.
6. Position rear edges of left and right-hand side
deflectors an equal distance from center pivot.
(See decal (L) on top cover).
B WASHER - lock, 1/2
C BOLT - hex head, 1/2 NC x 1 inch
D NUT - lock, smooth flange 3/8 NC
E BOLT - round hd, square neck 3/8 NC x 3/4"
F NUT - serrated flange, 1/2 NC
G BOLT - round hd, square neck 1/2 NC x 1"
H NUT - hex, 3/4 NC (Tighten lower nut to
100 ft.lbs. Then, holding lower nut with a
wrench, tighten top nut against lower nut.)
J WASHER - flat, 21/32 inch I.D.
K NUT - hex, 5/8 NC
ADJUST FLOAT
Adjust center float link to center of slot (A) and
adjust float.
See "Cutterbar Angle" and "Header Flotation" in
Operation section.