Quadrox Remote POS - Manual (Page 20)

Serial Port POS User & Installation Manual 20
Version 4.4 Series
Name – specify the name of the POS source.
Port – select the COM port to which the POS source is connected.
IP address – specify the IP address of the computer on which the POS source is
connected.
If the WebCCTV server is installed on the same machine the POS printer is
connected to, do not use the 127.0.0.1 IP address, but fill in the real IP-address. You
can check the real IP address in the TCP/IP properties of your machine.
Name (Serial Port POS) Screen
Click Next to enter the next POS Configuration Wizard Screen.
3.2.2.2 Recordings
This tab is a part of the POS Configuration Wizard. In this tab you are able to do the
following:
Add or delete cameras to record when a ticket is generated.
Multiple recordings can be assigned to one source. This way, a ticket can be
monitored from different cameras and angles.
Set the recording time before and after a ticket is generated. This is also called the pre and
post ticket recording interval.
A ticket movie is labelled recorded footage from a camera you attached to the ticket,
i.e. when a ticket comes in, the specific period of time recorded from a specified
camera is labelled and saved. Once the recording is complete, it appears as an alarm
movie. If there aren’t any recordings (i.e. when there is no activity) for the period
when the alarm occurs, recordings still will be present as the recordings will be forced
because an alarm was triggered and considered being high priority.
To add the camera to be recorded when a ticket is generated, follow the steps below:
1. Select the camera from the drop-down list.
2. Select the pre and post ticket label interval for each camera.