Retsch BB 100 - Manual (Page 13)

2/7/2012 Retsch GmbH
13
Starting the BB 100
The BB 100 may be started only when the crushing chamber
and fill hopper are empty.
Product which is present in the crushing chamber or fill
hopper before starting will cause the machine to block and can
cause damage to mechanical components.
0 I
Fig. 2
The ON/OFF and motor protection switch A/A1 is located
on the left, at the front of the BB 100. Fig. 2
Press button I.
The motor starts and the movable arm is set in motion.
The crushing operation can now be started, once the feed
hopper is in place.
Stopping the BB 100
The ON/OFF and motor protection switch A is located on
the left, at the front of the BB 100. Fig. 2
Press button 0
The motor is separated from the power supply and the
movable breaker arm comes to a stop.
Stop the BB 100 only when the crushing chamber has been
cleared of product.
Mechanical components could be damaged by blockage.
Empty the receiver drawer
Since the volume fed through the hopper can be greater than
the capacity of the drawer (V = 2000 ml), the drawer C will have
to be emptied from time to time.
To achieve the maximum fill level in the drawer, it is necessary
to shake it back and forth occasionally, without displacing the
drawer by more than 30 mm.
Fig. 3
Fig. 3