Retsch BB 100 - Manual (Page 6)

2/7/2012 Retsch GmbH
6
Technical specifications
Machine designation: BB 100
Utilization as per the intended purpose
This unit is not designed as a production machine, but as as
laboratory device intended for 8 hours single shift operation.
The BB 100 is suitable for reducing substances of medium to
extreme hardness and for brittle and tough materials.
The ultimate fineness can be as little as 1 mm and, depending on
the material being processed, may be even less.
Maximum recommended grain size for feedstock product is 50
mm.
The following is a list of some of the materials which can be
crushed using the BB 100:
Bakelite // bauxite // concrete // dolomite // ores // feldspar
// granite // graywacke // glass // limestone // gravel // coal
// coke // corundum // quartz // salts // refractory clay //
slag // silicates // silicon // sintered materials // cement
clinker, etc.
Do not make any modifications to the machine and use only RETSCH
approved spares and accessories.
Failure to comply will invalidate the CE declaration and guarantee.
Gap width adjustment range
From 0 to about 20 mm using a threaded spindle
Throughput rate and ultimate fineness
The performance data, throughput rate and ultimate degree of
fineness are functions of the fracture properties and the
hardness of the product being crushed and the gap width
selected. These values can only be determined empirically.
Receiver drawer nominal volume
approx. 2000 ml
Electrical protection classes
IP 54 for motor and overload switch
IP 65 for limit switch
Rated power
750 watts