Retsch MM 200 - Manual (Page 21)

5/21/2012 21 Retsch GmbH
Operating software display
When the buttons described below are pressed in the stand-by
mode the actual software version is displayed.
Display operating software:
Press buttons M- and SET simultaneously and keep pressed.
“S” appears in the display “memory”.
Leave operating software display :
Press STOP button.
Replacing the machine fuses
The following visible type fuses are required for the MM 200:
2 MT 3.15 A fuses
Replacing the fuses
• Unplug mains plug from the machine socket A
• By pressing the locking devices on the side of the fuse
compartment B these are released and can be pulled out.
• Replace fuses
• Insert fuse holder B so that it engages.
B
A
SET M-