Retsch PM 400 - Manual (Page 13)

08.02.2012 Retsch GmbH
13
Doc. Nr. GB 98.535.9999
Operation
Connecting the power supply
Ensure that the voltage and frequency of your mains supply
correspond to the values on the type plate of the PM400.
Plug the mains cable in the receiving socket Au on
the rear side of the equipment.
Plug the mains plug into the mains socket.
Switch on the main switch H
If the values on the type plate are not observed this can
result in damage to the electrical and mechanical
components.
D A E
When the PM400 is switched on for the first time the
language menu is displayed.
The language of your country must now be selected by
turning the control knob E. By pressing this knob selection is
confirmed and the display shows “Open lid”.
Opening / closing / emergency unlocking
of milling chamber
Open
The following steps are necessary in order to insert the milling
cup or milling cups and to clamp these:
Connect PM400 to the mains supply
Switch on the main switch on the rear side
Press button A
The safety closing device opens and the lid D can be swung
open. The milling chamber is now freely accessible.
Closing
Locking the milling chamber is possible only if the PM400 is
connected to the mains supply and the main switch on the
rear side of the machine is switched on.
Close the housing lid D
A sensor senses the closing pin of the housing lid and the
motor-driven lid closing mechanism is switched on.
The housing lid D is automatically closed.
H
Au