Retsch PM 400 - Manual (Page 3)

08.02.2012 Retsch GmbH
3
Doc. Nr. D 98.535.9999
Notes on these operating instructions
These operating instructions for the ball mill, type PM400,
give all the necessary information with regard to the areas
mentioned in the contents.
Instructions are given for the definite target group(s) in
each area, in order to ensure safe operation of the PM400
for its intended purpose. Knowledge of the relevant section
is essential for safe, proper handling in each target
group(s).
This technical documentation is intended as a reference and
instruction manual. The individual sections are complete in
themselves.
These operating instructions do not include repair
instructions. If repairs are necessary please contact your
supplier or Retsch GmbH direct: http://www.retsch.com
Warning instructions
Warnings are given by the following symbols:
Injury to persons
Damage to equipment
Observe instructions for use
Repairs
These operating instructions do not include repair
instructions. For your own safety repairs must be carried out
only by Retsch GmbH, an authorised agent or by Retsch
service technicians.
In this case please contact:
The Retsch agency in your country
Your supplier
Retsch GmbH directly
Your service address: