Retsch SM 100 - Manual (Page 37)

Cleaning and service
37
6.3.1.2 Remove the feed hopper
WARNING
2.W0004
Risk of injury to skin and hands
Fast rotating blades
– There is a risk of injury to hands, fingers and skin.
•
Never operate the device without the feed hopper.
Fig. 25: Mounting the feed hopper
• Disconnect the device from the mains by pulling the plug from the socket.
• Open the grinding area door (
T).
• Unscrew the three screws (
TS).
• Lift the feed hopper out of the device for cleaning.
Follow the instructions in the following section to mount the feed hopper.
6.3.1.3 Mount the feed hopper
• Open the grinding area door (
T).
• Place the feed hopper (
R) on the device (see diagram).
CAUTION
It is possible for the feed hopper (R) to fall from the device as long
as it is not secured by the two socket screws.
• Screw in the two socket screws supplied(S).
• Initially only tighten the screws loosely.
• Close the grinding area door (
T).
• Twist the rotary grip of the grinding area door.
• Align the feed hopper so that the plunger can be easily moved up and down
without tilting.
• Screw the three socket screws tight (10Nm).
TS
T
B
R
D
TS