BOXLIGHT CD-455m - Manual (Page 22)

14
S e t t i n g u p t h e P r o j e c t o r
Turning Off the Projector
If you want to turn off the projector for a short period of time,
press the
standby button on the keypad or remote. This blanks the
screen for fifteen minutes, but keeps the projector running. (You
can change the amount of time the projector stays in standby
mode; see “Standby Time” on page 27 for details.) After 15 min-
utes, the lamp goes out (the projector keeps running). To exit
standby mode, press the
standby button again. (It may take sev-
eral seconds for the projection lamp to reach full power and
project the image again.)
NOTE: To maximize lamp life,
allow the projector to run for at
least five minutes before turning
it off.
To completely power off the projector, press the Power button. If
you want to turn the lamp back on immediately, you must allow
about a minute for the lamp to cool. The lamp won’t light if it’s
too hot.