RKI Instruments 49-8103RK - Manual (Page 7)

49-8103RK Standby Battery • 7
Figure 4: Wiring the Standby Battery to a Beacon 200
11. Turn on power to the controller.
12. Turn on the controller.
13. When the controller has completed it’s startup sequence, re-connect the end of the
jumper wire to the battery terminal from which it was removed.
14. Close the standby battery housing door.
15. The on/off switch on the Beacon 110 and Beacon 200 controls AC power to the
instruments. Verify that the standby battery is installed properly by flipping the
switch on your controller to the off position and observing that the controller
continues to operate powered by the standby battery.
16. Flip the controller power switch to the on position.
Beacon 200
Housing
Controller Terminal Strip
+ +
Connections Made With
Wire Nuts Provided
Standby Battery
Shown Without
Door
Factory
Installed
Jumper
BAT
BAT +
+ CH1
OUT
+ CH2
OUT
RESET
RESET
BUZ
BUZ +