RKI Instruments 61-1001RK - Manual (Page 9)

61-1001RK Combustible Gas Detector• 5
Figure 3: Wiring the Hydrogen Detector to a Controller
Start Up
This section describes procedures to start up the hydrogen detector and place the detector
into normal operation.
Introducing Incoming Power
1. Complete the installation procedures described earlier in this manual.
2. Verify that the power wiring to the controller is correct and secure. Refer to the
controller operator’s manual.
GREEN
BLACK
RED
WH ITE
H2 LEL Detector
Red
Controller LEL
Detector Terminals
J-Box
Black
Green
Terminal Strip
Detector Wires
W hite