S&S Cycle Billet Air Cleaner Kit PN 106-5131 for Victory Motorcycles - Manual (Page 5)

5
3 – Remove the throttle body from the motorcycle by sliding it out from the right side (throttle cable side).
4 – With the throttle body removed, slide a large piece of clean plastic between the air box and the rubber intake manifold as illustrated in Picture 9.
This will help keep any debris from entering into the motor.
Note: Covering the intake manifold must be done before you move on.
Preparation for Victory® Air Box Removal
1 – Moving to the top side of the motorcycle, locate the breather hose and remove it from the air box. Picture 10 illustrates the breather hose
connected to the air box.
2 – Cover the end of the breather hose so no debris can enter the opening.
Note: A small plastic bag with a rubber band works well for this as illustrated in Picture 11.
3 – Detach the wiring harness from the right side of the frame as pointed out in Picture 11.
4 – Masking tape should be applied to the frame of the motorcycle as illustrated in Picture 11 to reduce the risk of scratching the frame when
removing the stock air box.
Picture 9
Picture 10 Picture 11
Breather
Hose
Masking
Tape
Masking
Tape
Breather Hose Covered
Wiring
Harness