S&S Cycle Sealed Air Cleaner - Manual (Page 3)

3
2- Remove the hardware packets from the box.
3- Install the SAC support bracket between the lower manifold bolt and the center case bolt.
4- Remove the Teardrop Cover and filter. Place teardrop cover on a non-scratch surface to protect the chrome finish.
5- Install the Deutsch Connector kit (supplied) on the appropriate motorcycle wiring (see SAC Wiring Diagram 1 page 6). Make sure to use the
connector on the SAC for reference. Also, remove the existing enrichment device and install the supplied S&S quarter-turn enrichment device.
See Picture 5.
6- Fitting locations marked below are available for the Fuel Overflow Tube and the Carbon Canister (see Evap. Diagram 2 on page 6).
Picture 2 Picture 3
Picture 4
Picture 6
1/8-27 NPT Fitting Locations
Picture 5