S&S Cycle Sealed Air Cleaner - Manual (Page 4)

4
7- Attach the case/head breather vent hose to the vent tube in the back of the backplate.
Vent hose must not contact hot or moving surfaces that could damage it and expose brakes or tires to crankcase oil/air mist. Oil on these
components could result in loss of control of motorcycle with death or severe injury to operator and others.
8- Connect wiring harness to the SAC connector and tuck excess wire so as not to contact any of the rotating components on the back of the SAC.
9- Install backplate by applying BLUE Loctite® (242) to the 3 ¼-20 x ¾” flat head socket cap screws. Position the gasket on the backplate and slide
two of the fasteners onto their respective holes to hold the gasket in place and mount the backplate to the carburetor. Install the third fastener
and tighten all three fasteners.
Be sure that there is nothing interfering with the rotating components on the back of the SAC.
10- To check the operation of the SAC at this time disconnect the wire from the starter, turn on the ignition and press the starter button. Turn off
the ignition and the valve should return to the closed position. If either operation fails check for interference with the rotating components.
Picture 7
WARNING
Picture 8
Picture 9 Picture 10
CAUTION