SATEC PM296 - Manual (Page 32)

Chapter 4 Setup Menus 24
Code Parameter Options Description
dAtA Data format 7E 7 bits, even parity
8n
∗ 8 bits, no parity
8E 8 bits, even parity
H.Sh Incoming flow
nonE
∗ No handshaking
control (handshaking) SOFt Software handshaking
(XON/XOFF protocol)
Hard Hardware handshaking (CTS
protocol)
Ctrl Outgoing flow control nonE ∗ RTS signal not used
(RTS/DTR) dtr RTS permanently asserted
(DTR mode)
rtS RTS asserted during the
transmission
Prn.P Printout period
1
∗, 2, 5, 10, 15, Time interval between
20, 30, 60 min successive printouts
COM2
Code Parameter Options Description
Prt.2
Communications
protocol
ASCII
∗
rtu
dnP3
ASCII protocol
Modbus RTU protocol
DNP3.0 protocol
rS Interface standard 422 RS-422 interface
485
∗ RS-485 interface
Addr Address
0
∗-99 ASCII
1
∗-247 Modbus
Powermeter address
bAud Baud rate 110 110 baud
300 300 baud
600 600 baud
1200 1200 baud
2400 2400 baud
4800 4800 baud
9600
∗ 9600 baud
19.20 19,200 baud
38.40 38,400 baud
dAtA Data format 7E 7 bits, even parity
8n
∗ 8 bits, no parity
8E 8 bits, even parity
CPtb ASCII compatibility
mode
diS
∗
, En
Disables/enables ASCII
compatibility mode. For more
information, see ASCII
Communications Protocol
Reference Guide