Sensaphone IMS-4000 Users manual - Manual (Page 25)

23
Chapter 1: Installation
If you select Option 1 you will see the IP address and status of the Host and all associated nodes. A sample is shown below:
Enterprise Status
Unit Type IP Status
IMS-4000 Monitor Host 10.1.4.10 Ok
NY_Node Node 10.1.4.17 Ok
Press any key to return to main menu
Option 2 will display the network configuration for the Host as well as web server, RAS, and two-way email settings. A
sample of Option 2 is shown below:
Network and Option Configuration
Physical Address 00:D0:C9:37:40:86
IP Address 10.1.4.10
Subnet Mask 255.255.255.0
Default Gateway 10.1.4.1
DNS Server 10.1.2.111
Enterprise name U.S. Widgets Inc.
Web Server Enabled
Web Status Security Enabled
Web Programming Option Enabled
Web Programming Security Enabled
Remote Access Server Enabled
RAS IP Port Address 0.0.0.0
Two-Way E-mail Responder Enabled
Microphone Listen-in Enabled
Datamodem Enabled
SNMP RO community public
SNMP RW community private
SNMP Agent Enabled
Allow remote configuration Disabled
Press any key to return to main menu
Option 3 will allow you to set all pertinent network settings listed under Option 2.
NOTE: You can remotely reconfigure the Host network settings using the IMS-4000 ConsoleView software if the Allow
Remote Configuration option is set to Y. However, the Host must initially be configured via the serial port before any
remote configuration is possible.
Option 4 allows you to configure or reconfigure the Enterprise name.
Option 5 allows you to configure the Web server. When Web security is enabled, a Profile Username & Password must be
entered to view the web page. A sample of the Web configuration menu is shown below:
Configure Web Server
1. Enable Web Server: Y/N
2. Enable Web Status Security: Y/N
3. Enable Web Programming option: Y/N
4. Enable Web Programming Security: Y/N
5. Return to main menu
Option 6 allows you to configure the RAS (Remote Access Server). This can be used to provide remote access to your net-
work via a dial-up connection to the IMS-4000 Host. Note that there are serious security risks associated with enabling this
feature. A sample of the RAS menu is shown below:
Configure Remote Access Server
1. Enable/Disable RAS Support
2. RAS IP address
3. Return to main menu
Enter option->
Option 7 allows you to Enable or Disable the two-way email feature.
Option 8 allows you to monitor on-site sound through either the built-in or an external microphone.