Sensaphone IMS-1000 Users manual User Manual

Ims-1000

Advertising

Table of contents

Document Outline

Chapter 1: Installation
- Introduction
  - Features
  - Technical Support
- About This Manual
- INSTALLATION and CONFIGURATION
- Physical Description
  - Front Panel Layout
  - Rear Panel
    - ON/OFF Switch
- Installation
  - Parts Required
- Operating Environment
- Network Configuration
- Parameter Descriptions
- Battery Maintenance
- IMS-1000 Specifications
- Operating Specifications
- Communications Specifications
- Environmental Monitoring
Chapter 2: IMS-1000 Programming
- Introduction
- Contacts
  - Voice Calls
- Connect Environmental Sensors
- Configuring Environmental Inputs
- Environmental Input Alarm Logic
- Trouble Alarms
  - Special Notes
- Configuring IP Alarms
- IP Alarm Setup
  - Programming Alarm Parameters
- Alarm Logic
  - Removing an IP Alarm
- Configuring a Network Video Camera
- Alarm Response via the Camera
- Saving and Loading Programming
- Updating Firmware
- Resetting to Factory Defaults
- Configuring the Relay Output
- Modes of Operation
- Setting the Output Mode
Chapter 3: Operation
- Alarm Delivery and Acknowledgment
- Alarm Acknowledgment
  - Sample Alarm Messages
- Voice Alarm Dialout
- Call-in Alarm Acknowledgment
Chapter 4: SNMP (Simple Network Management Protocol)
Chapter 5: IMS-1000 Sensors
- IMS-4810 Room Temperature Sensor
- IMS-4811 Room Temperature Sensor with display (Fahrenheit)
- IMS-4812 Mini–Temperature Sensor (Fahrenheit)
- IMS-4813 Room Temperature Sensor with display (Celsius)
- IMS-4814 Ultra Low Temperature Sensor
- IMS-4820 Room Humidity Sensor
- IMS-4821 Room Humidity Sensor with display
- IMS-4830 Water Detection Sensor
- IMS-4840 External Power Sensor
- IMS-4841 15A High Current Sensor
- IMS-4842 20A High Current Sensor
- IMS-4850 Dry Contact Bridge
- IMS-4851 4–20mA Bridge
IMS-4860 Door Switch
IMS-4861 Passive Infrared Detection Sensor
- IMS-4862 Smoke Detector Sensor
- IMS-4863 Airflow Sensor
- Technical Support for the IMS-1000 Sensors
Appendix A: Weekly Testing Procedure
Appendix B: Troubleshooting
Appendix C: IMS-1000 Accessories
Appendix D: IMS-1000 OID Information
Appendix E: Returning an IMS Unit for
Repair
Test Log
Chapter 7: IMS-4000 Sensors
- IMS-4810 Room Temperature Sensor
- IMS-4812 Mini-Temperature Sensor (Fahrenheit)
- IMS-4820 Room Humidity Sensor
- IMS-4821 Room Humidity Sensor with display
- IMS-4830 Water Detection Sensor
- IMS-4840 External Power Sensor
- IMS-4850 Dry Contact Bridge
- IMS-4851 4-20mA Bridge
- IMS-4860 Door Switch
- IMS-4861 Passive Infrared Detection Sensor
- IMS-4862 Smoke Detector Sensor
- Technical Support for the IMS-4000 Sensors
Appendix A: Weekly Testing Procedure
Appendix B: Troubleshooting
Appendix C: IMS-4000 Accessories
Appendix C: IMS-4000 Accessories
Appendix E: Returning an IMS Unit for Repair
Test Log