Skyjacker HB-916 - Manual (Page 2)

Front Installation:
1. With the vehicle on flat level ground, set the emergency brake &
block the rear tires / wheels.
2. Place a floor jack under the lower control arm’s front cross member
& raise the front of the vehicle. Place jack stands under the frame
rails, behind the front wheel wells & lower the frame of the vehicle
onto the jack stands.
3. Remove the front tires / wheels & remove the OEM brake line
brackets from the frame. (See Photo # 1)
4. Disconnect the OEM sway bar end links from the OEM steering
knuckles. (See Photo # 2)
5. Disconnect the OEM outer tie rod ends from the OEM steering
knuckles using a tie rod remover or other suitable tool. (See Photo
# 3)
6. Disconnect the OEM struts from the OEM lower A-arms. (See Photo
# 4)
Pg 2 I-HL130ST
Component Box Breakdown:
Part #: HL13ST / HL30ST
Hardware Bag Breakdown:
Part # HB-916
Item # Description qty
916FTN 9/16" FINE TREAD LOCK NUT 8
Item # Description qty Item # Description qty
613STS TOYOTA 1"-3" ADJ PERF STRUT 2 HB-916 HDWR BAG: 9/16" LOCK NUTS 1
RBF125 1.25" FLAT REAR BLOCK 2 (Included With HL30ST Box)
(Included With HL30ST Box) I-HL13ST INST SHEET: HL13ST / HL30ST 1
916X212X834U 9/16" X 2 1/2" X 8 3/4" U-BOLT 4
(Included With HL30ST Box)
Photo # 1
Photo # 2
Photo # 3
Photo # 4