Sportsliter Solutions 5010 Crossarm Bracket Mounting - Manual

SLS5010 CROSSARM BRACKET MOUNTING
INSTALLATION AND SERVICING INSTRUCTIONS
WARNING!
To reduce the risk of injury: Install and maintain to meet applicable codes; ensure that
all supporting structures are securely fastened before installing crossarm brackets and
luminaires; make safety first.
IMPORTANT:
The SLS 5010 bracket is required for use with the SLS Sportsliter whenever a crossarm has
an odd number of luminaires mounted on it. The SLS5010 bracket will be required for use
with the center mounted luminaire only (to allow a wider range of lateral aiming)
SLS5010 Crossarm Bracket Installation:
1. Ensure that your crossarm has adequate strength to support your desired
number of luminaires.
2. Drill a
13 ⁄
16”
diameter hole through the crossarm.
3. Secure the SLS5010 crossarm bracket to the crossarm with a 3 ⁄
4
-10
bolt, nut and lockwasher (provided by others). Minimum bolt and nut
specification: ASTM A-307/SAE-Grade 2 low carbon steel.
Tighten nut to 140ft. lbs.
4. Attach SLS Sportsliter luminaire to the SLS5010 crossarm bracket with
the
3 ⁄
4
-10 bolt, nut and lockwasher provided with the luminaire. Tighten
the nut to 180ft. lbs.
NOTE:
When the SLS5010 crossarm bracket is used with other types of luminaires, the installer
will need to provide an additional set of hardware to attach the luminaire yoke to the
SLS5010 bracket. Use the same type of hardware as called for in step #3 above, and
tighten nut to 180 ft. lbs.
Due to our continued efforts to improve our products, specifications are subject to change without notice.
Copyright © 2013 Hubbell Lighting All Rights Reserved.
For more information visit our web site: http://www.sportslighting.com/
SLS0028 5010 Instruction-A 1/14
Drawing Number: 268-0921-9901
Installation Instructions
SLS5010 BRACKET
SLS5010 BRACKET