SPYPOINT C6 User Manual - Manual (Page 10)

10
Settings
A : Photo quality (High/ Low)
B : Number of recorded files
C : Date/Time (MM/DD/YY, hh:mm)
D : Temperature (Celcius/Farenheit) (BF-6, BF-8, HD-7, M8, C6)
1. Turn OFF the camera.
2. Set the switch MODE to SET/TEST.
3. Turn ON the camera.
4. Press MENU/OK. An "H" will flash on the screen to indicate that the
camera is in High Resolution. Use the DOWN button if you want to reduce
the resolution to "L".
5. Press MENU/OK to set the date and time (mm/dd/yy, hh/mm). Use UP
and DOWN to change the blinking digit.
6. If applicable, press MENU/OK to go to the next option. Choose "F" or "C"
to display the temperature in Fahrenheit (°F) or Celsius (°C).
7. Once finished, press MENU/OK and turn OFF the system to save the
changes.
MODE
PHOTO
Allows the user to take photos. When the PHOTO mode is selected, the test
light in front of the camera will flash for 60 seconds to allow the user to
leave the area without being photographed.
VIDEO
Allows the user to take videos. When the VIDEO mode is selected, the test
light in front of the camera (see above) will flash for 60 seconds to allow the
user to leave the area without being recorded.
SET-TEST
Allows the user to test the detection system of the camera. When the SET/
TEST mode is selected, no photo or video is recorded. Pass in front of the
camera from left to right. When the camera detects a motion, the test light
blinks to indicate that the camera would normally have saved a photo or
video. If the system does not detect the movement, increase the detection
distance using the DISTANCE wheel or realign the system differently.
INSTALLATION WITH THE SUPPLIED STRAP
Recommended installation height: about 3 feet above the ground.
Do not place the camera facing the sun.
Note: When the photo resolution is set to "L", the video resolution is
automatically set to 320 x 240 or 640 x 480 (HD-7) and if the photo reso-
lution is set to "H", the video resolution is automatically set to 640 x 480
or 1280 x 720 (HD-7).
1. Insérez l’extrémité de la courroie dans la fente qui se trouve au dos du mécanisme. 2. Insérez la courroie dans la fente sous le levier et faites-la ressortir en arrière. 3. Créer une tension sur la courroie en la tirant vers la droite, puis rabattez vers la gauche le levier pour maintenir la position.
A
D
B
C
1 2 3
4
1