SPYPOINT IR-8 - Manual (Page 14)

26 27
Lithium battery pack with charger
The camera SPYPOINT IR-8 can be powered by a rechargeable
lithium battery LIT-C-8 (sold separately). This type of battery is
much less affected by cold temperatures and lasts up to 3 times
alkaline batteries. The solar panel SP-12V (sold separately) can
maintain the charge of the lithium battery at any time.
12 volts Power
The camera SPYPOINT IR-8 can also be powered from an
external 12 volts DC input. When using a 12 volt connection,
we recommend removing the alkaline batteries to prevent
surcharges. To find the accessories available for the 12 volts,
refer to the section « OPTIONS ».
electricity
The electrical power is recommended for security purposes. It
provides an instant trigger time when a movement is detected.
We recommend to remove the alkaline batteries when this
power is used. The purchase of a 12 volts DC adapter that can
provide a minimum of 800 mA is required.
Note: when using the electricity power, the Multi Shot mode
and the delay between photos are disabled as the camera starts
instantly every time it detects motion. Also, the imprinting
temperature on each picture is disabled.
MEMORY CARD
Using a memory card is required to operate the camera
SPYPOINT IR-8. When the camera is « ON » and no memory
card is used, the screen displays « Insert memory card ». The
SD slot of the camera has a 32 GB memory capacity. Before
inserting or removing the memory card, the camera must be
turned « OFF ». Failing to do so may cause loss of or damage
the pictures already recorded from the memory card. When the
SD card is full, the viewing screen indicates « DISK FULL ».
The following data shows an approximate quantity of photos
which can be recorded by the camera depending on the memory
card capacity.
English
In « TEST » mode, if the SD card is locked, the screen indicates
« CARD PROTECT » and the light in the front of the camera
remains on.
SETTINGS
turn the camera to « ON » and navigate the interface by
pressing «  », «  », «  » or «  », press « OK » for
selection. to modify the selection, press «  » and «  »
again and press « OK » to confirm. to return to the previous
menu press « BACK ».
PhOtO
When the « PHOTO » mode is selected, the
test light in the front of the camera winks for
60 seconds to allow the operator to walk away
from the camera.
VideO
When the « VIDEO » mode is selected, the
test light in the front of the camera winks for
60 seconds to allow the operator to walk away
from the camera.
English
Video
Photo