SPYPOINT SDB-85 - Manual (Page 6)

10 11
English
English
PROGRAMMING
Turn on the device and navigate the interface by pressing the
“UP” or “DOWN” and pressing “OK” to choose an option.
Edit with “UP” or “DOWN” and choose “EXIT” or press “OK”
to confirm.
Start Enable the detection system. During startup, a delay of
30 seconds elapses before the device begins operation.
Mode Sets how the device plays the audio files.
Random: The device randomly chooses an audio alert
among the available sounds on the SD card.
Single: The device uses the same audio alert. When
selecting this mode, the user must define the sound to
use among the available sounds on the SD card.
Playlist: The device uses a playlist of 5 predefined
sounds and follows the order of this preset. The user
must define the sounds to use from #1 to #5 among the
available sounds on the SD card. Each sound can be
added more than one time into the playlist.
Delay Allow the user to choose the time interval before the
device can detect again.
Play Allow the user to listen the audio alerts available on
the SD card or on the device.
Test Allow the user to test the device to determine if it
detects properly at the desired location. When the
«Test» mode is selected, no audio alert is issued.
Walk perpendicularly in front of the device. When the
SDB-85 detects motion, the test light turns on to
indicate that the device would normally be triggered.
Language Select a language for the menu.
ERROR MESSAGE
No MP3 on SD card No compatible MP3 file found on the SD
card.
Missing cfg MP3 on
SD card The files on the SD card are different from
the ones predefined on the device (see
Single or Playlist mode).
CONNECTION
1/8" mono audio output jack
Allow the user to connect the soundbox to an external speaker or
headphones. The internal speaker of the device is disabled when the
external jack is used.
1/8" mono input jack for external triggering
Allow the user to connect a closed loop contact to trigger the device.
TROUBLESHOOTING
The device triggers abnormally.
1. Rising sun or sunset may cause false detection. The device must
be reoriented.
2. Small animal may also cause false detection. Rise up the device.
3. Motion detector may sense animals through foliage.
4. The device must be set on a stable and immovable object. e.g.
large tree.
The device cannot play audio files from the SD card.
• Make sure that the audio files are in MP3 format and are stored at
the root of the SD card. Files saved in a folder or subfolder will
not be recognized by the device. MP3 files must be saved with a
maximum data rate of 192 kbps and file names must also contain
a maximum of 12 characters.
The red light in front of the device is blinking.
• The device is probably in startup mode and the light blinks for
30 seconds to allow the user to leave the premises without being
detected.
The device starts automatically after 2 minutes.
• If no activity is detected on the device for over 2 minutes,
it automatically starts up to avoid draining the batteries
unnecessarily.
12 volt Audio output Mono input