Don’t forget your airaid filter tune-up kit, Before! after – Stainless Works 200-233 Chevy/GMC Truck LS 4.8/5.3/6.0/6.2L 2009+ AIRAID Intake System User Manual
Page 2
14. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts,
and screws are tight.
15. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
Before!
After!
Instructions Revision
Date: 11/21/11
Don’t Forget Your AIRAID Filter Tune-Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions
that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are
missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION
IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
10. Reinstall the MAF sensor onto the filter
adapter using two 8-32 x 5/8” Allen Bolts (#13).
Do Not Use The Factory Screws!
Next install the urethane hump hose (#6) onto the
MAF with the two #64 hose clamps (#17). Leave
the clamps loose for now.
11. Install the 1/4” NPT x 3/8” Barb Fitting (#18)
into the Airaid Intake Tube as shown. Next install
the urethane coupler (#7) onto the throttle body
end of the tube using two #64 hose clamps (#17).
Tighten only the clamp on the tube.
12. Install the Airaid Intake Tube into the hump
hose first, and then onto the throttle body. Adjust
it for fit, and tighten the hose clamps. Next install
the 3/8” x 14” breather hose (#8) between the
1/4” NPT x 3/8” barbed fitting in the tube, and
the factory port on the valve cover.
13. Install the Airaid Premium Filter (#1) onto the
air filter adapter, and tighten the hose clamp. Next
install the provided weather strip (#9) onto the top
of the CAD. For ease of install, start at the inner
fender, and work your way towards the radiator.
Reinstall the beauty cover.