Stainless Works 350-199 Dodge Challenger / Charger / Magnum 5.7/6.1L 2005-2010 AIRAID Intake System - Manual (Page 2)

19. Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
20. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Instructions Revision
Date: 03/22/10
Don’t Forget Your AIRAID Filter Tune-Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions
that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are
missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION
IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
13. A. Install the urethane hump hose (#7)
onto the filter adapter using two #72 hose
clamps (#20), (Leave loose for now). B.
Install the large end of the reducing cou-
pler (#8) on the Airaid Intake Tube (#4),
using two #52 hose clamps (#19). Tighten
only the hose clamp on the tube. 15. Install the grommet (#21) into the hole
in the Airaid Intake Tube, and then gently
push the temperature sensor (removed in
step #4) thru the grommet until completely
seated.
A.
B.
14. Install the Airaid Intake Tube into the
hump hose first, and then onto the throttle
body, making sure it is flush against the
throttle body, adjust for fit, now tighten all
of the hose clamps.
16. If you are working on a 5.7L, skip to
step #17. If you are working on a 6.1L, re-
connect the factory breather tube to the
Airaid Intake Tube as shown. 18. Install the Airaid Premium Filter (#1),
onto the filter adapter inside of the CAD,
and tighten the hose clamp. Next install the
weather strip (#10) onto the top of the
CAD. 17. If you are working on a 6.1L, skip to
step #18. If you are working on a 5.7L,
install the breather hose (#9) from the
valve cover to the Airaid Intake Tube as
shown. Re-install the beauty cover onto the
engine.
Before! After!
Included with your Airaid Intake System is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
The C.A.R.B. E. O. Exemption for this intake kit only includes
2005 thru 2008 models at this time, and does not include the
Dodge Challenger. All other listed applications are pending.