Stainless Works Dodge Ram 1500 2009-2014 Exhausts - Manual (Page 3)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
15. Install the two remaining 3” hanger clamps- one on each tailpipe.
16. Insert clamp hangers into rubber hangers.
17. Install tips using (2) 3” clamps.
18. Tighten from front to back adjusting as needed
19. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the exhaust system, it will melt. Make sure to have at least
½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
20. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.
Your system may be tack welded at the joints/ clamps to reduce shifting of the
system during heating and cooling cycles. Make certain to disconnect the battery
before performing any welding.