Stainless Works Ford Raptor 2011+ 6.2L Lightning Exhaust - Manual (Page 3)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
13. Install tails into muffler and into OEM rubber hanger using (2) 3” clamps.
14. Adjust all pipes for fitment and tighten clamps. To ensure no movement during
extreme driving conditions, you can tack weld each joint together after tightening
the clamps. When doing this, you must first disconnect the battery!
15. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the exhaust system, it will melt. Make sure to have at least
½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
16. Lower the vehicle.
17. Reconnect the battery.
18. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.
Your system may be tack welded at the joints/ clamps to reduce shifting of the
system during heating and cooling cycles. Make certain to disconnect the battery
before performing any welding.