Summit SPW1103ADA - Manual (Page 24)

188635
The washing machine automatically monitors
the execution of particular functions during the
operation, and reports any detected failures. In
such cases both signal LED’s start flashing in
certain sequence. Flashing sequence changes in
accordance with the nature of the detected failure.
In some cases you may attempt correcting certain
failures yourself, so count the number of flashes
which repeat after a pause.
The machine signals failures immediately after
detecting them and stops the program, except for
heater failure, where the machine completes the
washing program without heating water.
Failures:
In certain cases you may remove the failure yourself
(Refer to chart on page 5):
2 - two flashes: door is not correctly closed;
3 - three flashes: water inlet problem;
7 - seven flashes: water outlet problem.
In all other instances mark the number of flashes
indicating the failure, switch off the machine and call
nearest authorized service center (LED’s continue
flashing until you switch the machine off).
Environmental interference (for example electrical
wiring) could induce signalization of different faults.
In such cases:
- switch the appliance off, and wait for a few
seconds;
- switch the appliance back on and repeat the
washing program.
If the fault repeats, call authorized service shop.
4
Troubleshooting