Regency Plateau PTO60 Outdoor Gas Burner - Manual (Page 14)

14
Regency Plateau™ PTO30 Outdoor Gas Fireplace
INSTALLATION
PTO60 ASSEMBLY
NOTE: PTO60 is two PTO30 units assembled end to end. You must pur-
chase two PT030s to make a PTO60.
1 Remove the large stand off on the end of the unit from both PTO30 units
- by removing 2 screws per side.
4. Line the two units up end to end. Screw fi reboxes together (one from
each side).
5. Reinstall burner trays.
6. Install units together into framing (refer to framing section). Secure in
place with nailing strips.
Large standoff
3. Lift burner tray off-burner tube can remain in place.
2. Remove 9 screws in locations shown below to remove burner tray (re-
move from both units).