Regency Plateau PTO60 Outdoor Gas Burner - Manual (Page 28)

28
Regency Plateau™ PTO30 Outdoor Gas Fireplace
INSTALLATION
ASSEMBLY INSTRUCTIONS FOR A STEEL STUD
TABLE FRAMING KIT FOR PTO60
Follow these instructions to construct a steel stud table for the PTO60 burner;
Overall dimensions = 24" W x 24" H x 79" L.
NOTE: PTO60 is two PTO30 units assembled end to end.
**Non-combustible fi nishing board not supplied with kit. Board may be purchased at your local hardware/building supply store.
Tools Required
1 power
drill
+ #2 phillips bit
1 hand
#2 screwdriver
(Phillips)
1 level
1
tape
measure
377-910 CONTENTS:
Top / Bottom (A) x 2
Vertical Supports - Corner (B) x 4
Vertical Supports - Inner (C) x 6
Vertical Supports - Outer (C) x 4
Wafer Screws 80