Regency Bellavista B36XT Medium Gas Fireplace - Manual (Page 54)

54
Regency Bellavista™ B36XT Gas Fireplace
INSTALLATION
15) Install the halogen bulb supplied with the kit.
Important: Use caution - do not touch the bulb during
installation. Use the plastic packaging as a protective
covering while installing the bulb.
17) Install the light diffuser by securing it to the rear log tray with 2
screws - see below.
14) Reinstall the rear log tray - secure with 2 screws.
13) Using the adhesive wire holder, neatly secure the loose wiring to
the base of the unit.
Ensure wiring does not come into contact with the fan blades
or any sharp metal edges.
Wire Clip
Gasket
Ground
Lug
16) Install a gasket over top of the bulb.
Installed diffuser shown below with 2 options:
a) With amber glass plate - for use with units without panels or
with brick panels. Left and right side tabs to be bent down 90
degrees as shown below (Image A).
b) Amber glass plate covered - for use with units using stainless
steel / black enamel panels as show below in Image B.
12) After the wiring has been connected, secure green ground wire to
ground lug as shown below.
Ground lug is located on the lower left corner inside the
bottom of the unit.
B
A
B