TaoTronics TT-BS009 - Manual (Page 8)

8
3. Scan the setting barcode “Finish Setting”. If it is programmed
successful , the scanner will issue a “beep beep” sound, but issue a
“beep beep beep” sound when fails.
e.g.：Set min. code length of Code 128 to 5 chars ：
○ 1 ： Open the manual and turn chapter "code128 ". Scan the setting bar code
“Scan Min. Code Length”.
Scan Min. Code Length（2 Digits；00~99，1*）
○ 2 ： Turn to the last page of this Manual Appendix 10 Parameter bar code,
scan the parameter bar code “0” and “5”：
0
5
○ 3 ： Scan “Finish Setting”, finish the setting。
Finish Setting