TerraWave TWSD16128PHC-UL User Manual
Page 2
10521 Gulfdale, San Antonio, TX 78216 I
www.terrawave.com
I Email:
I Phone: 210-375-8482
Version 1.1 - Page 2
Introduction
The TWSD16128PHC-UL is intended to be used with UL listed WLAN / Networking devices
both indoors and outdoors and to provide NEMA 3R protection with cooling and heating.
Maximum internal ambient temperature is 45 Degrees Celsius.
Before installing this product, read these instructions carefully. Failure to follow these
instructions could lead to damage to the product or cause hazardous conditions.
Check the ratings on the products you intend to place inside the enclosure solution to ensure
that they are suitable for the application.
Precautions
Read and understand all instructions before you begin installing the unit.
When installing and using this product, basic safety precautions should always be followed to
reduce the risk of electric shock, fire and injury to persons.
All wiring that is connected to the equipment must meet applicable local and national building
codes and network wiring standards for communications cable.
WARNING: To prevent the risk of electric shock and equipment damage, disconnect any
and all supply mains connected to the enclosure before installing, maintaining or trouble
shooting this product or any products inside the enclosure.
Keep these instructions for future reference.
Install only UL listed devices within the TWSD16128PHC-UL.
Follow all warnings and instructions marked on the product.
Insulation on all cables and wires installed by the service center must either be PVC, TFE,
PTFE, FEP, Neoprene, or Polymide.
Never install cable, connectors or jacks in a wet location unless they are specifically designed
for wet locations.
Never install this product during a lightning storm. There is a risk of electric shock from
lightning.
Never touch uninsulated communication wires or terminals.
Disconnect power before cleaning or servicing the unit.