Therasage Revolution Zero Gravity Recliner - Manual (Page 4)

1.
Plug the Far Infrared Heat controller, part D, into the lower socket on the right-hand side of the
control box located on the bottom left hand side of the back of the chair.
STEP THREE: Attach the electrical cords
Parts B, C, and D
STEP FOUR: Attach cervical & lumbar pillows
Part E
2.
Plug the Zero Gravity controller, part C, into the cord that comes out of the back of the chair.
1.
Zipper up the back cushion of the chair so the pull tabs are near the top.
3.
Connect the power cord, part B, that plugs into the electrical outlet directly into one side of
the converter. Connect the power cord from the base of the chair into the other side of the
converter.
4.
Attach the Far Infrared Heating Pads cords into the left-hand side of the control box. The cord
from the back cushion plugs into the lower socket and the cord from the foot cushion plugs
into the upper socket.
5.
Connect power cord to wall outlet. Turn power on. The On/Off switch is located on the top
left-hand side of the control box.
2.
Attach the cervical pillow by opening the snap and placing it through the eyes of the two
zipper tabs. To adjust the height of the cervical pillow, pull the two zipper tabs up or down.
3.
For additional lumbar support, place the lumbar pillow horizontally on the seat between the
arm rests.
CONGRATULATIONS!
ASSEMBLY IS NOW COMPLETE.
Please read all instructions before using this product and retain for future reference.