Titus Atlas Operating Room Ceiling System (AORCS) - Manual (Page 7)

I N S T A L L A T I O N & O P E R A T I O N M A N U A L
Atlas Ceiling System IOM
Installation & Operation
AORCS
7
Trim the cross and main tees as necessary to ensure a tight fit and seal to the perimeter tees. A fine tooth carbide tip miter saw is recommended for
cutting ceiling tees. PPE is required for cutting and installing the ceiling components. A full face shield, ear protection and proper gloves should be
worn for this procedure.
Perimeter Cross Tees
Perimeter connectors
Interior connectors
Main Tee
Perimeter Tees
Note: Hand tighten screws on interior
connectors to allow for installation of
interior cross tees.
"Quick Snap"
Connector
Cross Tee
Main Tee
Note: Trim perimeter cross tees to ensure a tight fit.
Tighten screws on perimeter connectors.