Undercover D-Ring Hinge Version - Manual

QUICK START INSTALL GUIDE
D-Ring Hinge Version
Refer to Model Specific Guide for
Special Notes Regarding Your Model
PAGE 1 For C
ust
omer S
er
vic
e or W
arr
ant
y Issues
, C
ontac
t UnderC
ov
er D
ire
ctl
y (866) 900-8800 w
w
w
.under
co
verinfo
.c
om
1
2
Install Parts Check List
Rear Mounting Bracket
A: 2 Hydraulic Struts
B: 8 Aluminum Clamps, Stainless
Steel Bolts, Washers, &
Lock Washers
C: 2 Front Mounting Brackets
D: 2 Rear Mounting Brackets
E: 2 J-Hooks and Wall Mounting
Screws
Tools Needed - 3/8” and 1/2” Wrench
or Socket
Mylar Tabs Included
NOTE: UnderCover Tonneaus are
designed from trucks that do not
have a bedliner (spray-in bedliners
pose no problem). Trucks that have plastic
drop in bedliners will require some minor trimming of the bedliner to ensure proper
placement of the mounting brackets. Any modifications must be made to the bedliner
and NOT the UnderCover mounting hardware. Modifications to the mounting
hardware could result in improper installation and will void your warranty.
A
B
C
E
D
NOTE: Brackets may differ from photo
Install the rear
bracket to the truck
bed rail near the
tailgate. Refer to the
Model Specific Guide
for measurements
and special notes.
Use 2 clamps per
bracket, install one
clamp in hole 1 and
one clamp in the
hole nearest the
tailgate that is unob-
structed by the truck
bed.
Do not over
tighten and distort
the brackets.
TOP VIEW PASSENGER SIDE
TRUCK BED RAIL
TRUCK BED RAIL
TAILGATE
CLAMP
BOLT
LOCK WASHER
FLAT WASHER
CLAMP INSTALLED
CORRECTLY
CLAMP INSTALLED
INCORRECTLY
BALL STUD
1
2
3
REAR BRACKET
REAR BRACKET
LOCK STRIKE
REAR BRACKET
REFER TO MODEL SPECIFIC
GUIDE FOR MEASUREMENT
FRONT BULKHEAD
TAILGATE