Undercover D-Ring Hinge Version - Manual (Page 4)

PAGE 4
Removal, Reinstallation & Wall Hanging Instructions
1
Minute
Removal
1
Minute
Re-Install
3 Easy Steps!
3 Easy Steps!
Wall Hanging Instructions
Step 1 - Release strut off of ball stud, be sure to
secure cover to prevent it from closing unex-
pectedly. Place loose end of strut in storage
clip. Repeat for other side.
Step 2 - With the cover closed, remove the
spiral rings at the front of the cover.
Note: Always be sure to remove the struts prior to
removing the spiral rings.
Step 3 - With some assistance, carefully lift the
cover off of the truck bed.
Step 1 - Place tonneau cover on the truck bed
positioning the female hinges over the spiral
ring tabs.
Step 2 - Install the spiral rings to the spiral ring
taps.
Step 3 - Open the cover and re-install the
struts. Be sure the front flap is hanging over
the bulkhead properly.
Step 1 - Prior to removing the tonneau,
mount the two J-Hooks provided, on the
garage wall. The hooks must have a mini-
mum height from the floor of 84”. Center
horizontally 32“ apart from each other.
For long bed trucks mount 98” from floor.
Step 2 - Remove your tonneau from the truck
bed.
Step 3 - Hang the tonneau vertically on the
hooks, under side against the wall, inserting
the hooks into the holes provided.
HYDRAULIC STRUT
(LARGE END)
ATTACHES TO COVER
(ROD END)
INCORRECT
PLACEMENT
OF FRONT FLAP
© 2012 UnderCover, Inc.
All rights reserved.
UnderCover, Inc.
P.O. Box 620
Rogersville, MO 65742