Undercover Hidden Hinge Version - Manual (Page 2)

QUICK START INSTALL GUIDE
Hidden Hinge Version
Refer to Model Specific Guide for
Special Notes Regarding Your Model
PAGE 2
Install the front
bracket to the truck
bed rail near the
bulkhead. Refer to
the Model Specific
Guide for measure-
ments and special
notes.
Use 2 clamps per
bracket, install one
clamp in hole 1 and
one clamp in hole 3.
If hole 3 is
obstructed by the
truck bed, use hole 2.
Do not over
tighten and distort
the brackets.
3
Front Mounting Bracket
TOP VIEW PASSENGER SIDE
PASSENGER SIDE
MARKS LINE UP WITH
SLOTS ON HINGE
FRONT BULKHEAD
TAILGATE
REAR BRACKET
FRONT BRACKET
REFER TO MODEL SPECIFIC
GUIDE FOR MEASUREMENT
MOUNTING POSTS
FRONT BRACKET
MOUNTED TO
BED RAIL
4-BAR HINGE
MOUNTED TO COVER
PASSENGER SIDE
1
2
3
4
Install Cover
With some assistance, set the bed cover on the truck bed. Slide the slots
in the 4 bar hinges (attached to the cover) over the posts on the front
mounting brackets. Push the cover forward to lock the hinges to the
mounting brackets. Lift the cover up from the rear and tighten the twist
knobs on both left and right hinges.
Install the hydraulic struts, attach large end to the cover and rod end to
the rear mounting bracket (these will snap into place, no tools needed).
For C
ust
omer S
er
vic
e or W
arr
ant
y Issues
, C
ontac
t UnderC
ov
er D
ire
ctl
y (866) 900-8800 w
w
w
.under
co
verinfo
.c
om