Unisteer 8011900-01 Chevrolet C10 Power Rack & Pinion Kit 1960-72 - Manual (Page 6)

Page 6 656410
5. Drive larger of two roll pins thru u-joint and shaft, then drive smaller roll pin
inside of the larger pin already in u-joint.
1967-1972 shaft kit only
1. Take off old linkage up to the end of the steering column.
2. Slide u-joint onto pinion shaft and insert pinch bolt. Leave all hardware loose
until everything is installed.
3. Slide upper u-joint on column so that the yokes are lined up in the same way and
insert pinch bolt.