Unisteer 8000930-02 Chevy II Manual Rack & Pinion Kit 1962-67 - Manual (Page 6)

pg. 6 655560
8) Install the column floor bracket and gasket on the interior. The tabs on the hole for the column
should face into the fire-wall, and may have to be bent more to accommodate the column sleeve.
On the inside of the fire-wall slip the column clamp over the two tabs. Reassemble the column
completely. This may be a convenient time to attach a U-Joint to the end of the column shaft.
9) Reinstall the assembled column, the column sleeve and bushing should protrude from the fire
wall about 1”. Slip the clamp over column sleeves and the tabs of the column floor bracket and
then tighten the clamp. Reattach any factory brackets under the dash.
Steering Shafts
A steering shaft is required to make this kit work; a steering shaft is not included with this kit due
to the variances in column, engine, and header combinations. Generally, three U-joints and two
sections of shaft and a support are needed. Unisteer has three different shaft kits available for
this rack and pinion kit depending on what column (factory or an aftermarket) you are using.
Each kit includes three U-joints, two sections of shaft, and a bracket with support bearing. The
bracket has been made to bolt to the frame rail.
*If you decide to source your shafting supplies elsewhere, the pinion size on the rack is a 9/16-26
spline.
Alignment Specs.
Toe: 1/16 to 1/8 inch in
Camber: ¼ degree positive
Caster: 1.5 – 2 degree positive
UNISTEER® Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
(02/12/07)
Last Revised 06/13/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.